The introduction is as follows:
Introduction:
1.      First print the image onto the film, you’d better choose 6 color to print, for example: Epson R230,ink printer or laser printer.
2.      Choose photo type to print
3.      Make the crystal surface clean by clean paper
4.      Pour little glue onto the crystal, and put the film (picture put down side) onto the crystal with glue, then swaying the crystal come-and-go. make the glue besprinkle the film, there must be no bladder, if there is bladder, then you have to extrude the bladder by using a hard card(such as bank card),after this you should check it by turn around the crystal to see if there is something not correct
      (Above operation should avoid the infrared, and operate under the lamp-house)
5. Put the crystal to the machine, turn on the electric power, and open the light, about 1-2minutes get outside the crystal.
6. Take out the crystal, cut off the superabundance along the edge of the crystal using a knife.(if need slice, the operation is same to above operation